6. Install the filler panel into the empty drive bay.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 104
Replacing a 3.5-inch simple-swap hard disk drive:
Before replacing a 3.5-inch simple-swap hard disk drive, read the following
information:
v Inspect the drive tray for signs of damage.
v To maintain proper system cooling, do not operate the server for more than 10
minutes without either a drive or a filler panel installed in each drive bay.
v You have to turn off the server to install simple-swap drives in the simple-swap
drive bays.
To replace a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins “Safety” on page vii and “Installation
guidelines” on page 36
Attention: Static electricity that is released to internal server components
when the server is powered-on might cause the server to halt, which might
result in the loss of data. To avoid this potential problem, always use an
electrostatic-discharge wrist strap or other grounding system when you work
inside the server with the power on.
2. Unlock the left-side cover.
Note: You must unlock the left-side cover to open or remove the bezel. When
you lock the left-side cover, it locks both the cover and the bezel.
3. Open the bezel (see “Removing the bezel” on page 331).
4. Remove the existing 3.5-inch simple-swap hard disk drive (see “Removing a
3.5-inch simple-swap hard disk drive” on page 348).
Chapter 6. Removing and replacing components 349
To Next Page
Loading...
