If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 116.
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and
“Installation guidelines” on page 33.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see “Removing the server top cover” on page 36).
Note: You might have to remove the PCIe riser-card assembly to access the
USB (hypervisor) connectors.
4. Locate the USB (hypervisor) connector on the system board in which you want
to install the flash device (see “System-board internal connectors” on page 26
for the location of the connectors for the embedded hypervisor USB flash
device).
5. Make sure that the lockbar on the USB (hypervisor) connector is in the unlock
position (down).
6. Align the USB flash device with the connector on the system board and push it
into the connector until it is firmly seated.
7. Slide the lockbar up to the locked position until the lockbar is seated firmly.
Lockbar
USB Hypervisor key
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 116.
100 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
Need help?
General