Appendix A. UEFI/POST error codes
UEFI/POST diagnostic error codes can be generated when the server starts up or
while the server is running. UEFI/POST codes are logged in the IMM event log in
the server.
For each event code, the following fields are displayed:
Event identifier
An identifier that uniquely identifies an event.
Event description
The logged message string that appears for an event.
Explanation
Additional information to explain why the event occurred.
Severity
An indication of the level of concern for the condition. The severity is
abbreviated in the event log to the first character. The following severities
can be displayed:
Table 27. Event severity levels
Severity Description
Informational An informational message is something that was recorded for
audit purposes, usually a user action or a change of states that is
normal behavior.
Warning A warning is not as severe as an error, but if possible, the
condition should be corrected before it becomes an error. It
might also be a condition that requires additional monitoring or
maintenance.
Error An error typically indicates a failure or critical condition that
impairs service or an expected function.
User response
Indicate the actions that you should take to resolve the event.
Perform the steps listed in this section in the order shown until the
problem is solved. After you perform all of the actions that are described
in this field, if you cannot solve the problem, contact IBM support.
The following is the list of the UEFI/POST error codes and suggested actions to
correct the detected problems.
© Copyright IBM Corp. 2012 297
To Next Page
Loading...
Need help?
General