6. Reconnect the external cables; then, reconnect the power cords and turn on the
peripheral devices and the server.
Note: You must wait approximately 10 seconds after you connect the server to
input power before the power-on button becomes active.
7. Start the Setup utility and reset the configuration.
v Set the system date and time.
v Set the power-on password.
v Reconfigure the server.
See “Using the Setup utility” on page 127 for details.
Removing a PCI riser-card assembly
To remove a PCI riser-card assembly, complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and the
“Installation guidelines” on page 33.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
3. Slide the server out of the rack, if installed in a rack.
4. Remove the top cover (see “Removing the server top cover” on page 206).
5. If an adapter is installed in the PCI riser-card assembly, disconnect any cables
that are connected to the adapter.
6. Grasp the front and rear of the PCI riser-card assembly at the blue touch-points
and lift it out of the PCI riser-card slot on the system board.
PCI riser-card assembly
(full height, half-length)
7. Remove the adapter, if necessary, from the PCI riser-card assembly.
8. Set the adapter and PCI riser-card assembly aside.
258 System x3750 M4 Types 8722 and 8733: Installation and Service Guide
To Next Page
Loading...
Need help?
General