IBM System x3750 M4 Type 8722 User Manual

9. Align the drive in the drive bay and slide the drive into the CD/DVD drive
bay until the drive clicks into place.
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 116.
Installing a PCIe riser-card assembly
For the location of the PCIe riser-card slot on the system board, see “System-board
internal connectors” on page 26.
To install a PCIe riser-card assembly, complete the following steps:
1. Read the safety information that begins on page “Safety” on page vii and the
“Installation guidelines” on page 33.
2. Turn off the server (see “Turning off the server” on page 21) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external
cables from the server.
3. Remove the top cover (see “Removing the server top cover” on page 36).
4. Remove the riser-card filler.
5. If you are installing adapters into the PCIe riser-card assembly (see “Installing
an adapter” on page 66).
6. Align the PCIe riser-card assembly with the PCIe riser-card connector on the
system board and align it with the slot on the chassis; then, lower it into the
server and press down firmly until the riser-card assembly is seated correctly in
the connector on the system board.
PCI
riser
slot
PCI riser-card assembly
(full height, half-length)
Riser-
card
filler
If you have other devices to install or remove, do so now. Otherwise, go to
“Completing the installation” on page 116.
Chapter 2. Installing optional devices 65

IBM System x3750 M4 Type 8722 Specifications

General

Brand	IBM
Model	System x3750 M4 Type 8722
Category	Server
Language	English