IBM System x3750 M4 Type 8722 User Manual

2. Touch the static-protective package that contains the new ServeRAID M5120
SAS/SATA adapter to any unpainted surface on the outside of the server; then,
grasp the adapter by the top edge or upper corners of the adapter and remove
it from the package.
3. Install the adapter on system board.
a. Reinstall the RAID cache card onto the adapter, if one was removed earlier
(see “Replacing a RAID cache card” on page 252.
b. Align the ServeRAID M5120 adapter so that the keys align correctly with
the connector on the system board.
c. Insert the adapter into the connector on the system board until it is firmly
seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board or the adapter.
d. Reconnect the cables to the adapter and to the cache card.
e. Go to step 5 on page 232.
4. Install the adapter on the PCIe riser-card assembly.
a. Reinstall the RAID cache card on the adapter, if one was removed earlier
(see “Replacing a RAID cache card” on page 252).
b. Align the ServeRAID M5120 adapter so that the keys align correctly with
the connector on the riser-card assembly.
c. Insert the adapter into the connector on the riser-card until it is firmly
seated.
Attention: Make sure that the adapter is seated correctly. Incomplete
insertion might cause damage to the system board, the adapter, and the
PCIe riser card assembly.
Chapter 6. Removing and replacing components 231

IBM System x3750 M4 Type 8722 Specifications

General

Brand	IBM
Model	System x3750 M4 Type 8722
Category	Server
Language	English