4000001b-00000000 Management Controller [arg1]: Configuration restored from a file by user [arg2].
Explanation: The specified user has restored the Integrated Management Module (IMM) configuration from a
previously saved configuration file. Some configuration settings might require that the IMM be restarted before they
take effect.
Severity: Info
Alert Category: none
Serviceable: No
CIM Information: Prefix: IMM and ID: 0027
SNMP Trap ID:
Automatically notify Support: No
User response: Information only; no action is required.
4000001c-00000000 Watchdog [arg1] Screen Capture Occurred .
Explanation: An operating-system error has occurred, and the screen capture was successful.
Severity: Info
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0028
SNMP Trap ID: 22
Automatically notify Support: No
User response: If there was no operating-system error, complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet-over-USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
If there was an operating-system error, check the integrity of the installed operating system.
4000001d-00000000 Watchdog [arg1] Failed to Capture Screen.
Explanation: An operating-system error has occurred, and the screen capture failed.
Severity: Error
Alert Category: System - other
Serviceable: No
CIM Information: Prefix: IMM and ID: 0029
SNMP Trap ID: 22
Automatically notify Support: No
User response: Complete the following steps until the problem is solved:
1. Reconfigure the watchdog timer to a higher value.
2. Make sure that the IMM Ethernet over USB interface is enabled.
3. Reinstall the RNDIS or cdc_ether device driver for the operating system.
4. Disable the watchdog.
5. Check the integrity of the installed operating system.
4000001b-00000000 • 4000001d-00000000
Appendix D. Integrated management module II (IMM2) error messages 359