IBM X3850 X6 User Manual

Chapter 7. Management 233
/etc/inittab
Add the parameter that is highlighted in bold at the end of the /etc/inittab file, as shown in
Example 7-11.
Example 7-11 The /etc/inittab file
id:3:initdefault:
co:2345:respawn:/sbin/agetty ttyS1 115200 vt100-nav
[root@localhost etc]#
7.9.3 How to start a SoL connection
In this section, we explain how to connect to X6 through SoL.
Connecting to the X6 server with SoL
You can use Telnet or SSH to connect to the your X6 server. Follow these steps:
1. Start a Telnet/SSH session to the IMM2 IP address.
2. Log in to the IMM2. The default user id is USERID and the default password is PASSW0RD,
where the 0 is a zero.
3. The IMM CLI main page appears as seen Figure 7-34.
Figure 7-34 IMM CLI main page
4. Start SoL with the console 1 command.
5. The SoL console starts and you see whatever is transmitted over the SoL connection
(for example, the UEFI setup windows).
For additional information about using SoL commands, see the following website:
http://www.ibm.com/support/entry/portal/docdisplay?Indocid=MIGR-5086346

IBM X3850 X6 Specifications

General

Chipset	Intel C602J
Network Controller	Integrated quad-port Gigabit Ethernet
Processor	Up to four Intel Xeon E7-4800 v2 series processors or Intel Xeon E7-8800 v2 series processors
Memory	Up to 6 TB of DDR3 ECC Registered DIMMs (RDIMMs) or Load-Reduced DIMMs (LRDIMMs)
Form Factor	4U rack server
Storage	Up to 24x 2.5" hot-swap SAS/SATA HDDs or SSDs
Expansion Slots	Up to 11 PCIe 3.0 slots
Power Supply	Up to four 1400W or 900W hot-swap power supplies
Memory Type	DDR3 RDIMM/LRDIMM
Storage Controller	ServeRAID M5210 SAS/SATA controller
RAID Support	RAID 0, 1, 5, 6, 10, 50, 60
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware