110
8
MEMORY OPERATION
8
This is useful for transferring frequency and operat-
ing mode while operating in memory mode.
When you have changed the frequency or operat-
ing mode in the selected memory channel.
• Displayed frequency and mode are transferred.
• Programmed frequency and mode in the memory
channel are not transferred, and they remain in
the memory channel.
q Push [PBT/M-ch/RIT] momentarily to select the M-
ch/RIT function, if the twin PBT is selected.
•[PBT/M-ch/RIT] indicator (Green) goes out.
w Select the menu
M
-
2
.
•Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group
M
.
•Push [MENU/GRP] momentarily one or more times to
select the menu
M
-
2
.
e Push [F-4
V/M
] momentarily to select the memory
mode.
r Rotate [M-ch] to select the memory channel to be
transferred.
•“ ” appears if the selected memory channel is a
blank channel (and does not have contents). In this
case transferring is not possible.
t Push [F-4
V/M
] for 1 sec. to transfer the frequency
and operating mode.
•Displayed frequency and operating mode are trans-
ferred to the VFO.
y Push [F-4
V/M
] momentarily to select the VFO
mode.
To Next Page
Loading...
