Icom IC-7000 Instruction Manual

D
Manual notch function
83
5
FUNCTIONS FOR RECEIVE
q Push [MNF/ADJ] for 1 sec. to enter the manual
notch filter set mode.
w Push [F-2
NF1
] or [F-3
NF2
] to select the desired
filter ON and OFF.
e Rotate [DIAL] to adjust the selected filter fre-
quency.
•Push [F-4
NW
] to toggle the filter width from narrow,
middle and wide.
r Push [MNF/ADJ] (or push [
Z
( MENU / GRP )]) to exit
the manual notch filter set mode.
While adjusting the manual notch filter, noise may
be heard. This comes from the DSP unit and does
not indicate an equipment malfunction.
[MENU/GRP]
[MNF/ADJ]
[F-2] [F-3]
[F-4] [DIAL]
The manual notch function can be used in SSB, CW,
RTTY and AM modes.
➥ Push [MNF/ADJ] momentarily to turn the manual
notch function ON and OFF.
• “ ” appears when manual notch function is in use.
•Set the frequency for manual notch filtering via the
manual notch filter set mode. (shown below)
•Even when both of the manual notch filters, “
NF1
” and
“
NF2
,” are set to OFF in the manual notch filter set
mode, “
NF1
” is automatically turned ON if the manual
notch function is ON.
[MNF/ADJ]
Appears
D Manual notch filter set mode

Icom IC-7000 Specifications

General

Input voltage	13.8 V
Microphone included	Yes
Product type	Portable CB radio
Product color	Black
Housing material	-
Frequency range	0.5 - 455000 MHz
Channels quantity	503 channels

Weight and Dimensions

Depth	180 mm
Width	167 mm
Height	58 mm