Icom IC-7000 - Backlight(Switches); Bright (LCD); Contrast (LCD); Display Set Mode

126
13
SET MODE
13
■ Display set mode
To adjust the LCD contrast or backlight, wait until
the LCD becomes stable (10 min. or more after turn-
ing power ON). This is an inherent characteristic of
LCDs and LCD backlights and does not indicate a
transceiver malfunction.
1
Contrast (LCD)
This item adjusts the contrast of the LCD from 0% to
100% in 1% steps.
 4 0 %
40% (default)
2
Bright (LCD)
This item adjusts the brightness of the LCD from 0%
to 100% in 1% steps.
 7 0 %
70% (default)
3
LCD Unit Bright
This item adjusts the brightness of the LCD unit from
0% to 100% in 1% steps.
 4 0 %
40% (default)
4
LCD Flicker
This item adjusts the flicker of the LCD from 0% to
100% in 1% steps.
Icom recommends using the default value. But if
you feel the flicker on the LCD, and it is too con-
cerned, you adjust this item.
 6 5 %
65% (default)
5
Backlight(Switches)
This item adjusts the brightness of the switches from
0% to 100% in 1% steps.
 5 0 %
50% (default)
6
Display Type
This item sets the LCD screen type. There are 3 se-
lectable types: A, B, and C.
A
A-type LCD screen (default)