Icom IC-7000 - D Characters Code for My Call; D Codes for Memory Name Contents; D DTCS Code and Polarity Setting; D Repeater ToneTone Squelch Frequency Setting

149
17
CONTROL COMMAND
D
Character’s code for my call
D
Codes for memory name contents
To send or read the desired memory name settings, the char-
acter codes, instructed codes for memory keyer contents as
above, and follows are additionally used.
• Character’s code— Alphabetical characters
• Character’s code— Symbols
D
Split/Duplex frequency setting
The following data sequence is used when sending/reading
the split or duplex frequency setting.
D
Repeater tone/tone squelch frequency
setting
The following data sequence is used when sending/reading
the DTCS code and polarity setting.
D
DTCS code and polarity setting
The following data sequence is used when sending/reading
the DTCS code and polarity setting.
Fixed digit: 0 1st digit: 0–7 2nd digit: 0–7 3rd digit: 0–7 Transmit polarity: 0= Normal 1= Reverse Receive polarity: 0= Normal 1= Reverse
q
XX0XX
we
X
100Hz digit: 0–2 10 Hz digit: 0–9 1 Hz digit: 0–9 0.1 Hz digit: 0–9 Fixed digit: 0* Fixed digit: 0*
q*
00XXX
we
X
*Not necessary when setting a frequency.
1 kHz digit: 0—9 100 Hz digit: 0 (fixed) 100 kHz digit: 0—9 10 kHz digit: 0—9 10 MHz digit: 0 (fixed) 1 MHz digit: 0—4 Direction: 00=+ direction 01=— direction
q
0XXXXXX
we
0
r*
*No need to enter for duplex frequency setting.
Character ASCII code Character ASCII code
a–z 61–7A — —
Character ASCII code Character ASCII code
!21#23
$24%25
&26¥5C
?3F ” 22
’27`60
+2B–2D
:3A;3B
=3D<3C
>3E ( 28
)29[5B
]5D{7B
}7D|7C
_5F
–
7E
@40
Character ASCII code Description
0–9 30–39 Numerals
A–Z 41–5A Alphabetical characters
space 20 Word space
– 2D Symbol
. 2E Symbol
/ 2F Symbol