■ Basic transmit operation
D Transmitting
25
3
BASIC OPERATION
q Push [PTT] (microphone) to transmit.
• The [TX] indicator lights red.
w Release [PTT] (microphone) to return to receive.
Before transmitting, monitor your selected op-
erating frequency to make sure transmitting
won’t cause interference to other stations on
the same frequency. It’s good Amateur practice
to listen first, and then, even if nothing is heard,
ask “is the frequency in use” once or twice, be-
fore you begin operating on that frequency.
■ Dial lock function
The dial lock function prevents accidental changes
caused by the tuning dial.
➥ Push [LOCK] to turn the dial lock function ON and
OFF.
•“LOCK” indicator lights while the dial lock function is
activated.
Lights while the dial lock function is activated.
[LOCK]
D Maximum output power
q
Push [POWER] for 1 sec. to turn power OFF.
w While pushing [LOCK], push [POWER] to turn
power ON and enter initial set mode.
e Push [MENU] one or more times to select “1 MAX
POWSET,” if necessary.
• [M-CH] or [Y]/[Z] can also be used.
r Rotate the main dial to select the desired maximum
output power.
•Maximum output power is selectable “0.5,” “1,” “2.5,” “5”
or “10.”
•Default setting is “10.”
t Push [POWER] to turn power OFF, and ON again.
[M-CH] [LOCK][MENU]
[POWER]
[Y]
[Z]
To Next Page
Loading...
