Icom IC-703 - Section 7 Semi-Conductor Information; Transistors and FETs Symbols; Diodes Symbols

44
4
RECEIVE AND TRANSMIT
T3 RPTR-T SCN (Repeater tone scan)
During repeater operation, you can detect the tone
frequency necessary to open a repeater. (see p. 45)
The default is 88.5 Hz.
FM-T
T3 T-SQL SCN (Tone squelch tone scan)
During tone squelch operation, you can detect the
tone frequency necessary to communicate using tone
squelch. (see p. 43)
The default is 88.5 Hz.
FM-TSQL
T1 RPTR TONE
This item selects a subaudible tone for FM-T mode
operation to access a repeater. There are 50 tones
available from 67.0 Hz to 254.1 Hz (see table at
right).
• Available subaudible tone frequencies (Unit: Hz)
The default is 88.5 Hz.
FM
T2 TONE SQL
This item sets a subaudible tone for tone squelch use.
The same subaudible tone frequencies as for re-
peater operation are available—see above
The default is 88.5 Hz.
FM
While M4 is selected in FM mode, push [(F-2)TON] for
1 sec. to enter the FM tone set mode.
D FM tone set mode
67.0
69.3
71.9
74.4
77.0
79.7
82.5
085.4
088.5
091.5
094.8
097.4
100.0
103.5
107.2
110.9
114.8
118.8
123.0
127.3
131.8
136.5
141.3
146.2
151.4
156.7
159.8
162.2
165.5
167.9
171.3
173.8
177.3
179.9
183.5
186.2
189.9
192.8
196.6
199.5
203.5
206.5
210.7
218.1
225.7
229.1
233.6
241.8
250.3
254.1
4