Icom IC-91A - Call Sign Programming

35
7
DV MODE OPERATION (Optional UT-121 is required for IC-91A)
7
y Push [
≈≈
](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [
≈≈
](6) to move the cursor right; push [
ΩΩ
](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter your own call sign.
• Up to a 8-digit of call sign can be set.
• If an un-necessary character is entered, push [
≈≈
](6) or [
ΩΩ
](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all char-
acters following the cursor.
• When programming a note (Up to a 4-digit for operating radio
type or area, etc.), go to step i, otherwise go to step !0.
i Push [
≈≈
](6) several times to set the cursor beside “/” indi-
cation.
o Repeat steps t to y to program the desired 4-character
note.
!0 Push [ï](5) to store the programmed call sign with note
and returns to MY CALL SIGN screen.
!1 Push [MENU/LOCK] to return to frequency indication.
M01M01
MYCALL MYCALL
/IC91 /IC91
:SET
:BACK
:SEL
:EDIT
CLR:CLR
MY CALL SIGN
r
M01M01
M†
/
MY CALL SIGN
r
:SET:SET
:SEL:SEL
:CUR:CUR
CLR:CLRCLR:CLR
A/a:CHARA/a:CHAR
AB
†
[DIAL] ↔ [
∫∫
](2)/[
√√
](8) [ï](5) ↔ [
≈≈
](6)
1
2
3
4
5
6
8
9
10
11
12
13
14
15
16
17
18
19