36
7 DV MODE OPERATION (Optional UT-121 is required for IC-91A)
DD
Station call sign programming
Station call sign must be programmed for the specified sta-
tion call as well as repeater operation in both digital voice and
low-speed data communications.
q Select B band as the main band.
(p. 14)
w Enter “UR” in call sign set mode.
• YOUR CALL SIGN screen is displayed.
e Rotate [DIAL]
†
to select the desired call sign memory,
“U01” to “U60.”
r Push [
≈≈
](6) to enter call sign programming mode.
• The 1st digit blinks.
t Rotate [DIAL]
†
to select the desired character or code.
• Push [A/a](3) to change the character group from “AB” (alpha-
betical characters; capital letters), “12” (numbers) and “/” (sym-
bols) in sequence.
y Push [
≈≈
](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [
≈≈
](6) to move the cursor right; push [
ΩΩ
](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
u Repeat the steps t and y to enter the desired station call
sign.
• Up to an 8-digit of call sign can be set.
• If an un-necessary character is entered, push [
≈≈
](6) or [
ΩΩ
](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all char-
acters following the cursor.
i Push [ï](5) to store the programmed call sign and returns
to YOUR CALL SIGN screen.
o Push [MENU/LOCK] to return to frequency indication.
To Next Page
Loading...
