93
11
MENU SCREEN OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
DD
Digital monitor
Sets the desired monitoring mode during digital mode opera-
tion from “Auto,” “Digital” and “Analog.”
• AUTO : The transceiver sets monitoring mode to FM
and DV according to the received signal.
(de-
fault)
• DIGITAL : Monitors in DV mode.
• ANALOG : Monitors in FM mode.
DD
Digital repeater setting
When accessing a digital repeater with a call sign different
than is programmed, the repeater call sign can be stored into
“RPT1” and/or “RPT2” automatically by reading the repeater’s
transmission. The stored repeater’s call sign can be re-called
when selecting the repeater call sign. (default: ON)
DD
RX call sign auto write
When an individual station call is received, the calling station
call sign can be automatically set in “UR.” (default: OFF)
DD
Repeater call sign auto write
When accessing a repeater with a call sign different than is
programmed, the repeater call sign can be set into “RPT1”
and/or “RPT2” automatically by reading the repeater’s trans-
mission. (default: OFF)
The transceiver sets the received repeater call sign for op-
eration. Therefore, when a different call sign is set for op-
eration, the previously set repeater call sign will be lost.
To Next Page
Loading...
