Icom IC-M803

15
BASIC OPERATION
5
5
■ e-mail operation
The IC-M803 is ready for HF e-mail operation— up
to 160 e-mail frequency channels, and a connection
terminal for an e-mail modem are available.
Independent e-mail frequencies with operating mode
and lter settings can be selected with a push of a
button, or group/channel selector rotation, for simple
operation.
D Operation
1. Connect your PC through an e-mail modem to
[AF/MOD] on the IC-M803 main unit front panel.
L See page 69 for connection details.
2. Start up the e-mail application.
L First, set up the necessary information given
from your provider for e-mail operation.
3. Push [◄] or [►] until is displayed in the
Software Key area.
4. Push then rotate [CH/GRP], or push
[▲] or [▼] to select the desired e-mail channel.
L [GRP] changes in 20 channel steps.
L Selectable e-mail frequencies may di󰀨er,
depending on your provider.
5. Follow the e-mail application instructions for
operation.
D e-mail Filter
When an e-mail CH is selected, the lter type of the
selected channel can be changed to Wide, Middle, or
Narrow.
1. Push [◄] or [►] until is displayed in the
Software Key area.
2. Push
.
• The lter width of the selected e-mail channel is
changed.
NOTE:
• For e-mail operation, you MUST make a contract
with an HF e-mail provider and purchase an
e-mail modem from the provider, or your dealer.
E-mail frequencies may need to be set by your
dealer, depending on your modem selection.
Ask your dealer for details.
• When a PC is connected, the remote controller
is inhibited and the screen as shown below
is displayed. Push to resume
operation with the remote controller.
• When an e-mail CH is selected, the Voice
scrambler function cannot be turned ON.