Icom IC-M803

52
7
DSC OPERATION
■ Receiving DSC calls (other)
D Receiving a Geographical Area call (continued)
3. Push , and then to return to
the Main screen.
TIP: When you push in step 2, the
countdown will be paused. Push to
resume the countdown.
D Receiving a Test call
NOTE: When the “Test ACK” is set to “Auto,” the
transceiver automatically sends an Acknowledgment.
(p. 57)
In that case, both the TX and RX calls are stored in
the Transmitted and Received Call Logs.
When a Test call is received:
• The alarm sounds until you turn it OFF.
• “Received Test Call” is displayed.
1. Push
to turn OFF the alarm.
2. Push the Software Key below the intended
operation.
: Ignores the call and returns to the Main
screen.
: Puts the RX task on hold, and returns
to the Main screen.
: Sends an Acknowledgment “Able to
comply.”
: Sends an Acknowledgment “Unable to
comply.”
L Rotate [CH/GRP] to conrm the call contents.
L See pages 27 and 28 for details of the Software Key
functions in the DSC Task mode.
3. Push , and then to return to
the Main screen.
TIP: See page 43 for details on sending an
Acknowledgment.
Rotate