Icom IC-M803 - DSC OPERATION; Entering Position and Time Data

26
7
DSC OPERATION
■ Entering the position data and time
4. Enter the UTC time, and then push .
• After is pushed, the entered position
data and time is set, and the DSC setting screen is
displayed.
5. Push [MENU] or to return to the Main
screen.
• The entered position data and time, and “Manual” is
displayed in the Position data and Time area.
A Distress call should include the vessel’s position,
date, and time. If no GPS data is received, manually
enter the position and Universal Time Coordinated
(UTC) time.
NOTE:
• Manual entry is disabled while valid GPS data is
received.
• The manually entered position and time is valid
only for 23.5 hours.
1. Open “Position Input.”
[MENU] > DSC Settings > Position Input
2. Enter the latitude, and then push
.
L To select ʻNʼ (North latitude) or ʻSʼ (South latitude),
select “N” or “S” on the screen and push [ENT], or
push a Keypad key when the cursor is on the ‘N’ or ‘S.’
3. Enter the longitude and the UTC time, and then
push .
L To select ʻWʼ (West longitude) or ʻEʼ (East longitude),
select “W” or “E” on the screen and push [ENT], or
push a Keypad key when the cursor is on the ‘W’ or ‘E.’
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate