6
6
D Program
The Program scan searches the selected channel
(p. 66)
Start Frequency
End Frequency
(p. 65)
Type
1. (p. 12)
2.
is displayed in the
Software Key area.
3. Push
4. is displayed in the
Software Key area.
5. Push to start a scan.
6. Push again to stop the scan.
Start
End
■ Using the Voice Recorder
The transceiver has an automatic recording function
that can record the last 120 seconds of the receiving
audio. You can playback the audio that you could not
hear clearly.
z Starts recording automatically when the signal is
received.
•
is displayed when recording the received audio.
• Stops recording 3 seconds after the signal disappears,
or when the channel is changed.
•
is displayed when recording is stopped.
• The recorded voice data is erased when the
D Playback the recorded voice
1. is displayed in the
Software Key area.
2. Push to play the recorded audio.
• Playing the recorded audio is automatically started.
• The play window is displayed as shown below.
TIP:
• To stop playing the recorded audio, push [CH/
L
•
L Set between -2’00 to 0’00.
•
L
• is displayed when playing the recorded
audio.
• is displayed when playing the recorded
audio is stopped.
• When the play window is displayed, recording
the received audio is stopped.
To Next Page
Loading...
