Icom IC-M803

35
DSC OPERATION
7
7
■ Sending DSC calls (other)
D Sending an Individual call
An Individual call enables you to send a DSC signal to
only a specic station.
You can communicate after receiving the
Acknowledgment “ACK (able).”
L You can send an Individual call to a pre-entered Individual
address, or manually enter the address before sending.
(p. 24)
1. Push .
• The “COMPOSE NON-DISTRESS” screen is displayed.
L To display the screen from the Menu screen:
[MENU] > Compose Non-Distress
2. Select “Address.”
3. Select an Individual address, or “Manual Input.”
NOTE: When you select “Manual Input” in
this step, push the Keypad key to manually
enter an Individual ID.
4. Select “Call frequency.”
5. Select a Call frequency, or “Manual Input.”
NOTE: When you select “Manual Input” in
this step, push the Keypad key to manually
enter a Call frequency.
6. Select “Voice Frequency.”
7. Select a voice frequency, or “Manual Input.”
NOTE: When you select “Manual Input” in
this step, push the Keypad key to manually
enter a voice frequency.
8. Push
to send an Individual call.
• “Transmitting Individual Call” is displayed, and then
“Waiting for ACK” is displayed.
L See pages 27 and 28 for details of the Software Key
functions in the DSC Task mode.
► Continued on the next page.
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate