Icom IC-M803

51
DSC OPERATION
7
7
• Monitor the Voice frequency that the calling station
specied.
L Rotate [CH/GRP] to conrm the call contents.
L See pages 27 and 28 for details of the Software Key
functions in the DSC Task mode.
3. Push , and then to return to
the Main screen.
TIP: When you push in step 2, the
countdown will be paused. Push to
resume the countdown.
D Receiving a Geographical Area call
When a Geographical Area call is received:
• The emergency alarm sounds until you turn it OFF.
• “Received Geographical” is displayed.
1. Push to turn OFF the alarm.
L When “Accept after 10 sec.” or “Ignore after 10 sec.”
is selected in “CH Auto Switch” setting, the countdown
is displayed on the bottom of the window. (p. 58)
After 10 seconds have passed since is
pushed, the screen will move to the DSC Task screen,
or return to the Main screen.
2. Push the Software Key below the intended
operation.
: Ignores the call and returns to the Main
screen.
: Puts the RX task on hold, and returns
to the Main screen.
: Pauses the countdown.
: Enters the DSC Task mode immediately.
• Monitor the Voice frequency that the calling station
specied.
L Rotate [CH/GRP] to conrm the call contents.
L See pages 27 and 28 for details of the Software Key
functions in the DSC Task mode.
► Continued on the next page
Rotate
Rotate