Icom IC-M803

37
DSC OPERATION
7
7
D Sending a Group call
A Group call enables you to send a DSC call to only a
specic group.
L You can send a Group call to a pre-entered group
address, or manually enter the address before sending.
(p. 24)
1. Push .
• The “COMPOSE NON-DISTRESS” screen is displayed.
L To display the screen from the Menu screen:
[MENU] > Compose Non-Distress
2. Select “Message Type.”
3. Select “Group.”
L “Category” is fixed to “Routine.”
4. Select “Address.”
5. Select a Group ID, or “Manual Input.”
NOTE: When you select “Manual Input” in
this step, push the Keypad key to manually
enter an Group ID.
► Continued on the next page
4. Confirm the contents.
5. Push to send an Individual
Acknowledgment.
• “Transmitting Individual ACK” is displayed, and then
“Individual Call” is displayed.
L See pages 27 and 28 for details of the Software Key
functions in the DSC Task mode.
6. Hold down [PTT] to talk.
7. Push , and then to return to
the Main screen.
TIP: When “Individual ACK” is set to “AUTO,” the
transceiver automatically transmits an Individual
Acknowledgment. (p. 57)
Rotate
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate
+
Push
Rotate