Icom IC-M92D - Position Reply and Manual Settings; Manual Reply for Position Request Calls

40
8
DSC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Manual Reply:
Enter “POSITION REPLY” in the DSC CALLS menu. q
 •IfnoPositionRequestcallhasbeenreceived,the“POSITION
REPLY” item will not be displayed.
Select a desired Position Request call to reply to, using w
[Y]/[Z], then push [ENT].
The Position Reply call confirmation screen is displayed. e
Push [CALL] to transmit the acknowledgement call.
While transmitting the reply call, the screen as shown be- r
low is displayed, and then returns to the normal operating
mode.
When no GPS receiver is connected, and both position
and time have been manually programmed, the screen as
shown below appears. Edit your latitude and longitude posi-
tion and UTC time data as follows:
Push [CHG], then edit your latitude and longitude position
and UTC time data.
•Selectadesirednumberusing[Y]/[Z]/[Ω]/[≈].
 •Push[ENT]tosetit.
 •Tomovethecursor,selecteitherarrow,“←” or “→,” then push
[ENT].
 •SelectN:NorthlatitudeorS:Southlatitudewhenthecursor
is on the ‘N’ or ‘S’ position.
 •SelectW:WestlongitudeorE:Eastlongitudewhenthecur-
sor is on the ‘W’ or ‘E’ position.
MENU ➪ DSC Calls ➪ Position Reply
(Push [MENU]) (Push [Y]/[Z] , then push [ENT].)