IFM Electronic AC402S - Configure AS-I Master

SmartPLC SafeLine AC4S with fieldbus interfaces
59
7.4.3 Configure AS-i master
42481
To configure the AS-i masters of the device, use the following function blocks:
Name
Description
Reference
Set_Mode
Set operating mode of the AS-i master (projecting mode
or protected operation)
→ Set_Mode (→ S. 150)
Set_ASi_Config
Set diagnostic functions of the AS-i master (double
address recognition, earth fault detection)
→ Set_ASi_Config (→ S. 146)
Set_AdressMode
Set automatic addressing of the AS-i master
→ Set_AddressMode (→ S. 145)
>
7.4.4 Configure AS-i slaves
42480
To configure the AS-i slaves, that are connected to the device, use the following function blocks:
Name
Description
Reference
Set_SlaveAddress
Change address of an AS-i slave
→ Set_SlaveAddress (→ S. 155)
Set_SlaveParameter
Change I/O configuration and ID codes (IO, ID, ID1, ID2)
of an AS-i slave
→ Set_SlaveParameter (→ S. 159)
Set_SlaveExtendedID1
Extended ID1 of an AS-i slave
→ Set_SlaveExtendedID1 (→ S. 157)