SmartPLC SafeLine AC4S with fieldbus interfaces
2 Safety instructions
Content
General safety instructions ....................................................................................................................... 9
Required background knowledge ............................................................................................................. 9
28333
>
2.1 General safety instructions
41415
Read this document before setting up the product and keep it during the entire service life.
Only use the product for its intended purpose.
If the operating instructions or the technical data are not adhered to, personal injury and/or damage to
property may occur.
Improper or non-intended use may lead to malfunctions of the device, to unwanted effects in the
application or to a loss of the warranty claims.
The manufacturer assumes no liability for any consequences caused by tampering with the device or
incorrect use by the operator.
► Observe these operating instructions.
► Adhere to the warning notes on the product.
>
2.2 Required background knowledge
43060
This document is intended for specialists. Specialists are people who, based on their relevant training
and experience, are capable of identifying risks and avoiding potential hazards that may be caused
during operation or maintenance of the product.
To program AC4S, the people should also be familiar with the software CODESYS 3.5 and the
CODESYS Safety extension.
The people should also have knowledge of the following topics:
Requirements on safety-relevant programming
Standards DIN EN ISO 13849 and DIN EN 62061
To Next Page
Loading...
