ILX Lightwave LDC-3700 Series User Manual

SYNTAX DIAGRAM
PARAMETERS None. The response will be in the form:
-where
1 = ready, 0 = not ready.
POINTS OF
INTEREST
After this query is issued and a response of 1 is received, the LDC-3700 Series Laser Diode
Controller
will be ready for the user to enter a current value via the LAScr:LDI command (see
Section 6.4.2).
In local operation, the ready state during the calibration cycle is indicated by a beep (if the
beeper
is enabled) which is issued by the LDC-3700 Series Laser Diode Controller when it is
ready for
a value to be entered.
EXAMPLES
"LASer:CAL:LDI?" -response:
1, means the LDC-3700 Series Laser Diode Controller is
ready for the user to enter a current value via the LASer:LDI command
"LASer:Cal:W?" -response:
0, means the LDC-3700 Series Laser Diode Controller is not
yet ready for the user to enter
a LASER current value.
CI Front Panel LASer:CAL:LDV
Remote
The LASer:CAL:LDV command is used to enter the LASER voltage measurement calibration mode.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English