ILX Lightwave LDC-3700 Series User Manual

SYNTAX DIAGRAM
PARAMETERS None.
POINTS OF
INTEREST
After this command is issued, the LDC-3700 Series Laser Diode Controller will allow
calibration of the laser voltage measurement.
This procedure is outlined in Section 6.4.5.
The LASer:CAL:LDV? query may be used to determine if the LDC-3700 Series Laser Diode
Controller is ready for the user to enter a value.
EXAMPLES
"Las:CAL:Ldvw -action: the LDC-3700
Series Laser Diode Controller enters calibration
mode for LASER voltage.
"Las:Cal:LDV" -action: the LDC-3700 Series
Laser Diode Controller enters calibration mode
for LASER voltage.
Front Panel
The LASer:CAL:LDV? query is
used to determine that the LDC-3700 Series Laser Diode Controller is
ready for a value to be entered during the calibration cycle of the LASer:CAL:WV mode.
SYNTAX DIAGRAM
PARAMETERS None. The response will be in the form:
-where
1 = ready, 0 = not ready.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English