ILX Lightwave LDC-3700 Series User Manual

EXAMPLES "Las:Dis:SetN -action: enables the LASER display for the set point of the selected mode: LDI,
MDI (IPD) or MDP PPD)
ZAS:Dis:Set" -action: enables the LASER Wlay for the set point of the selected -lay
mode.
w Front Panel LASer:DISplay:SET?
Remote
The LASer:DISplay:SETI
query returns the status of the (LASER DISPLAY) SET switch.
SYNTAX DLAGRAM
PARAMETERS
None.
The response will be in the form:
-where the
response is an <nrf value>.
POINTS OF
INTEREST The set point display will not time out when REMOTE operation is used. (It will be
continuously displayed.)
In local operation, the status of the SET switch is determined by visually inspecting the LED
on the switch (ht = ON).
EXAMPLES
"LAS:DISPLAY:SETIW
-respom: 0, means the measured value is enabled for the LASER
display.
"Las:Dis:Set?" -response: 1, means the set point value is enabled for the LASER display.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English