ILX Lightwave LDC-3700 Series User Manual

EXAMPLES
"LAS:ENAB:COND 129" -action: enables the LASER status condition register so that the
Open circuit and LASER current Limit conditions will be summarized in the status byte
(bit 3).
Laser:Enable:Cond #HFF97" - action: enables the LASER status condition register so that
any and all of the above conditions will be reported in the status byte register (bit 3).
Front Panel LASer: ENABle:COND?
W Remote
The LASer:ENABle:COND?
query returns the value of the status condition enable register of the LASER
operations.
SYNTAX DIAGRAM
PARAMETERS None. The response will be in the form:
-where the
response is the sum of the following:
1 - LASER Current Limit
2 - LASER Voltage Limit
4 - N/A
8 - Power Limit
16 - Interlock Disabled
32 - N/A
64 - NIA
128 - Open Circuit
256 - Oup,ut is Shorted
5 12 - Output Changed to be InlOut of Tolerance
1024 - Output WOE State
2048 - Ready for Caliiration Data State
40% - Calculation Error
8192 - Error Communicating LASER Board
16384 - Software Error in LASER Control
32768 - LASER Eeprom Checksum Error
POINTS OF
INTEREST
The enabled LASER conditions can be set by using the LASer:ENABle:COND command
The LASER condition
status can be monitored by the LASer:COND? query.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English