ILX Lightwave LDC-3700 Series User Manual

EXAMPLES "LAS:ENAB:COND?" -response: 17, means that the Laser Current Limit and Interlock
disabled LASER conditions
will be reported (in summarized form) to the status byte (bit 3).
"Radix Hex; Laser:Enable:Cond?" -response: #HFF97, means that all of the above conditions
will be reported (in summarized form) to the status byte (bit 3).
Front Panel
W Remote
LASer: ENABle: EVEnt
The LASer:ENABle:EVEnt command sets the status event enable register of the LASER operations. These
events are summarized in bit 2 of the status byte register.
SYNTAX
DLAGRAM
PARAMETERS
An <nrf value> whose sum represents the bits which are enabled:
1 - LASER Current Limit
2 - LASER Voltage Limit
4 - N/A
8 - Power Limit
16 - Interlock Changed State
32 - N/A
64 - NIA
128 - Open Circuit
256 - Output is Shorted
5 12 - Output Changed to be InIOut of Tolerance
1024 - Output WOff State Changed
2048 - New Measurements Taken
40% - Calculation Errc-
8 192 - Er Cornmum ~ng LASER Board
16384 - ,
mre Error m LASER Control
32768 - LASER Eeprom Checksum Error
POINTS OF
INTEREST
The enabled LASER
events can be read by using the LASer:ENABle:EVEnt? query. The
LASER event
status can be monitored by the LASer:EVEnt? query.
The enable registers normally
retain their values at power-up (as they were at powerdown)
unless the powera status clear flag is set true (see *PSC, Chapter 3).
EXAMPLES
"LAS:ENAB:EVENT
136" -action: enables the LASER status event register so that the Open
circuit
and Power limit events will be reported (in summanzed form) to the status byte (bit 2).
"Laser:Enable:Event #HFF9Bn -action: enables the LASER status event register so all of the
above events
will be reported (in
ed form) to the status byte (bit 2).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English