ILX Lightwave LDC-3700 Series User Manual

Front Panel LASer:ENABle:EVEnt?
N Remote
The LAScr:WABlc:EVEnt?
query returns the value of the status event enable register of the LASER
operations.
SYNTAX DIAGRAM
PARAMETERS
None. The response
will be in the form:
-where the
response is the sum of the following:
1 - LASER Current Limit
2 - LASER Voltage Limit
4 - NIA
8 - Power Limit
16 - Interlock State Changed
32 - NIA
64 - NIA
128 - Open Circuit
256 - Output is Shorted
5 12 - Output Changed to be Inlout of Tolerance
1024 - Output WOff State
2048 - New Measurements Taken
40% - Calculation Error
8 192 - Error Communicating LASER Board
16384 - Software Emr in LASER Control
32768 - LASER Eeprom Checksum Emr
POINTS
OF
INTEREST
Ttbe enabled LASER events can be set by using the LASer:ENABle:EVEnt command. The
LASER event
status can be monitored by the LASer:EVEnt? qucry.
EXAMPLES "LAS:ENAB:EVE?"
-response: 1040, means that the Output on/d state change and
Interlock changed LASER events will be reported (in mmmuhd form) to the status byte
register (bit 2).
"Radix Hex; Las:Enab:Eve?" -response: #HFF9B, means that all of the above events will be
reported (in
xi form) to the status byte register (bit 2).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English