ILX Lightwave LDC-3700 Series User Manual

POINTS OF
INTEREST
EXAMPLES
I3 Front Panel
-where
the response is an <nrf value>.
Response is the measured laser output current, for either low or high bandwidth modes.
This measurement is updated approximately once every 600 mSec.
Inlbcalmode,themeasuredlaseroutputcuircntwouldbedbypressingtheIswitcharrd
visuaUy reading the LASER display.
"L.AS:ldi?" -response: 30.0, means the measured laser output current is 30.0 mA.
"Laser:LDI?" -response: 100.0, means the measured laser output NI-ent is 100.0 mA.
Remote
The LkLDV command sets the laser voltage for caliiration of the laser voltage measurement.
SYNTAX DLAGRAM
PARAMETERS
An cnrf value> which represents the @wr) output voltage, in volts.
POINTS OF
INTEREST
Set point is the same for both low and high baradwidth output modes.
EXAMPLES
"Las:LDV 4" -action: enters a value of 4.000 volts.
"LAS:ldv
I .OW don: enters a value of 1 .O2S volts.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English