PARAMETERS
None. The response will be in the form:
-\vilere the response is an
<nrf
value>.
POINTS
OF
INTEREST
The current limit is valid for all modes
of
Laser operation.
In local operation, the limit current value is read by selecting the
LIM
I
parameter, and
visually reading the LASER display.
EXAMPLES
"LAS:LIM:Il?" -response: 40, means the laser current limit is 40
mA.
"Laser:LIM:Il?" -response: 500, means the laser current limit
is
500
mA
(LDC-3712B only).
Front Panel
LASer:LIMit:I2
Remote
The LASer:LIMit:I2 command sets the LASER current limit value for the 200 mA range
on
the
LDC-i722B.
(Not applicable for LDC-3742B).
,
,,)j
white
'
en"
space> value>
PARAMETERS
An <nrfvalue> which represents the LASER'limit current, in
mA.
POINTS OF
INTEREST
The current limit is in effect in all modes of operation of the laser output.
In
local operation, the limit current is entered
by
selecting LIM I parameter, pressing and
holding
in
the
(PARAMETER)
SET switch, adjusting the
ADJUST
knob until the desired
\due is displayed, and then releasing the SET switch.
ESAhlPLES
"LAS:LIM:I2
180"
-action: the LASER current limit is set to 180 mA.
":Laser:Limit:I2 160" -action: the
LASER
current limit
is
set to
160
mA.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
