ILX Lightwave LDC-3700 Series User Manual

PARAMETERS
None. The
response will be in the form:
-where the response is
an <nrf value>.
POINTS OF
INTEREST
The
response is in mW. The response is valid, even when the unit is not in amstant P mode.
This measurement is updated approximately once every 600 mSec.
In local mode, the me. photodetector power would be read by pressing the (LASER
DISPLAY)
I,, switch and visually reading the LASER dqlay, assuming P mode is selected
and CALPD is not zero.
EXAMPLES "Las:Mode:MDP; Las:Calmd 460; Las:MDp?" -response: 100.0, means 100 mW of
photodetector power.
This feedback is controlling the laser current output.
"LAS:MODE:MBW; LAS:MDP?" -response: 20.0, means 20 mW of photodetector power,
but photodiode
monitor cum is not controlling the laser omput aunnt.
Front Panel
LASer:MODE:
Remote
The LASer:MODE: command path is
used to get to the LDC-3700 Series Laser Diode Controller's laser
mode selection
commands.
The following commands may be reached directly from the LASer:MODE: command path.
W Front Panel
W Remote
-
The LASer:MODE:IHBW command selects laser high bandwidth constant current mode.
SYNTAX DIAGRAM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

ILX Lightwave LDC-3700 Series Specifications

General

Brand	ILX Lightwave
Model	LDC-3700 Series
Category	Controller
Language	English