1 - 8
Transpector XPR 3+ Operating Manual
1.13.4 Operating Temperature
Transpector XPR 3+ is designed to operate within a temperature range of
5°C to 50°C (41°F to 122°F).
1.13.5 Humidity
Transpector XPR 3+ is designed to operate in an environment with up to
98% relative humidity.
1.14 Computer System Requirements
Refer to the FabGuard Explorer Operating Manual (PN 074-528-P1) for computer
system requirements.
1.15 Software Installation
Refer to the FabGuard Explorer Operating Manual (PN 074-528-P1) for information
on installing the software and setting up the protocols necessary to ensure proper
software operation.
1.16 Hardware Installation
The following steps must be performed to install Transpector XPR 3+
Gas Analysis System.
1 If the optional Isolation Valve option was purchased with the
Transpector XPR 3+ install the Isolation Valve, see section 1.16.2 on page
1-11.
2 If the optional Pirani Gauge Interlock was purchased with the
Transpector XPR 3+ mount the Pirani Interlock Weldment Assembly, see
section 1.16.3 on page 1-17.
3 If the optional Pirani Gauge Interlock was purchased with the
Transpector XPR 3+ mount the Pirani Gauge, see section 1.16.4 on page
1-18.
4 Install the Transpector XPR 3+ Sensor, see section 1.16.5 on page 1-19.
5 Install the Transpector Electronics Module, see section 1.16.6 on page 1-22.
6 Install the Communications cables, see section 1.16.8 on page 1-23.
7 Install the 24 V DC Power Supply, see section 1.16.9 on page 1-24.
8 If the optional Pirani Gauge Interlock was purchased with the
Transpector XPR 3+ install the Transpector XPR 3+ Interlock Cable, see
section 1.16.10 on page 1-24.
To Next Page
Loading...
