Inficon Transpector XPR 3+ User Manual

2 - 1
Transpector XPR 3+ Operating Manual
Chapter 2
Connecting Transpector XPR 3+
2.1 Introduction
Transpector XPR 3+ uses Ethernet as its default communications method.
Transpector XPR 3+ has an IP address and a MAC address.
IP addresses are used as a means of identifying individual devices on a network.
IP addresses are unique on a network but not universally, that is, meaning that only
one device on a network can have a specific IP address but two devices on
separate networks can have the same IP address.
MAC addresses are another identifier that are unique for each device. MAC
addresses are never duplicated. FabGuard uses IP addresses to locate and
identify sensors on a network.
2.2 General Networking Information
This section will discuss some of the general networking variables that can affect
the connection of Transpector XPR 3+.
2.2.1 IP Addresses
IP addresses can be set either manually or automatically:
 Static (manual) IP addresses are set by the user and are manually changeable
by the user
 Dynamic (automatic) IP addresses are automatically set by a Host
INFICON recommends using Static IP addresses for Transpector XPR 3+ but
allows for Dynamic IP addresses set through DHCP (Dynamic Host
Communication Protocol).
NOTE: When using Static IP addresses, a block of addresses should be reserved
for Static use and prohibited from being assigned by the DHCP server
(Host). This will avoid duplicate IP address conflicts from occurring.

Inficon Transpector XPR 3+ Specifications

General

Brand	Inficon
Model	Transpector XPR 3+
Category	Measuring Instruments
Language	English