Infors HT Multitron - Activating or Deactivating the Key Pad Lock (with a PIN); Activating or Deactivating the Key Tone

Multitron - Operating Manual
Operation
20 August 2020 Page 113 of 158
INFORMATION
When opening the door of the device, the table is stopped with
the maximum brake force, regardless which brake force is set.
7.7.5 Activating or Deactivating the Key Pad Lock (with a PIN)
Top display:
OPt and PIN
To prevent unauthorised persons making entries on the operating
panel, the key pad can be locked using a PIN. To do so, tap the SET
key (the sign
Setpoint appears) and then use the ON/OFF key to acti-
vate or deactivate the key pad lock.
If the key pad lock has been activated, you can then tap the OPTION
key followed by the SET key to enter a PIN (number between 0 and
9999). Once the PIN has been entered, this must be confirmed using
the ON/OFF key (the message
PIN OK appears on the top display).
INFORMATION
By entering the number “1756” (Super PIN), the PIN is deactivated
and set to zero.
INFORMATION
When the key pad lock is active, this information can be read out
via the Ethernet interface. In this way, when the device is remotely
controlled (e.g. using eve
®
), it can be determined and logged
whether the key pad lock is active or not.
7.7.6 Activating or Deactivating the Key Tone
Top display: bEEP
The key tone (clicking sound when tapping a key) can be activated or
deactivated. To do so, tap the SET key (the sign Setpoint appears)
and then use the ON/OFF key to activate or deactivate the key tone.