Multitron - Operating Manual
Options
Page 54 of 158 20 August 2020
4.10 Cable Pass-through
4.10.1 Setup and Function
A pass-through for cables or hoses can be installed on the right side
of the casing. This can be used to guide additional sensors or gassing
into the incubation chamber.
The pass-through reduces loss of heat and/or humidity and, if appli-
cable, gas consumption if cables or hoses have to be passed into the
incubation chamber.
The cable pass-through consists of a dividable cable-pass-
(1) into which slotted sealing elements (cable sleeves) (2) can be in-
serted. The cables are affixed and strain-relieved using cable sleeves.
Openings that are not required are sealed using a dummy sleeve. The
cable pass-through is screwed onto the inside of the casing. A suita-
ble screw driver (SW 4) is included to dismantle the removable part of
the cable pass-through bar (3).
1
2
3
To Next Page
Loading...
