Multitron - Operating Manual
Installation
Page 72 of 158 20 August 2020
6 Installation
Only the manufacturer’s qualified expert personnel or persons au-
thorised by the manufacturer may install and initially commission the
device. Hence, the following section only lists the requirements for
the installation location to be observed by the provider.
Installation and initial commissioning require trained expert per-
sonnel with sufficient experience. Errors during installation may
lead to dangerous situations or significant damage to property.
– Only the manufacturer’s expert personnel or person’s author-
ised by the manufacturer may install and initially commission
the device.
– The manufacturer must also be consulted if the device is sub-
sequently moved.
6.1 Operating Conditions at the Installation Location
To achieve optimal and reproducible results, the device should be set
up in stable ambient conditions without strong temperature or hu-
midity fluctuations. Changes in ambient temperature or humidity
(even short-term) can have a negative effect on the climate in the
incubation chamber.
Operating conditions
Temperature range 10 up to 30 °C
Humidity 10 up to 85 %
Restrictions
Do not expose to direct sun-
light
Do not expose to dust
Do not expose to vibrations
The device may only be set up indoors.
To Next Page
Loading...
