Infors HT Multitron - Specifications of Standard Parameters; Rotation Speed Parameter (Shaker Drive)

Multitron - Operating Manual
Technical Data and Specifications
Page 144 of 158 20 August 2020
12.4 Specifications of Standard Parameters
12.4.1 Rotation Speed Parameter (Shaker Drive)
Description
Value
Unit
Drive BLDC motor 48 VDC
Sensor Hall sensor
Controller PID controller
Throw (fix throw)
3, 25 or 50
mm
Throw (adjustable throw)
12.5, 19, 25, 50
mm
Increment
1
min
-1
Control precision
± 4
min
-1
Rotation speeds
INFORMATION
The actual rotation speed that can be achieved depends on differ-
ent factors, such as loading, vessel type (e.g. flasks with baffles) or
holder (e.g. clamps or Sticky Stuff).
The minimum rotation speed for all device variants is 20 min
-1
. The
maximum rotation speed of a unit depends on the throw and the
position of the unit in the stack:
Individual unit 3 mm 25 mm 50 mm
1000 min
-1
400 min
-1
350 min
-1
Two units stacked 3 mm 25 mm 50 mm
Upper unit 1000 min
-1
400 min
-1
350 min
-1
Lower unit 1000 min
-1
400 min
-1
350 min
-1
Three units stacked 3 mm 25 mm 50 mm
Upper unit 1000 min
-1
400 min
-1
300 min
-1
Middle unit 1000 min
-1
400 min
-1
350 min
-1
Lower unit 1000 min
-1
400 min
-1
350 min
-1