Infors HT Multitron - Markings on the Device; Identification Plate; Identification of the Throw

Multitron - Operating Manual
Setup and Function
Page 34 of 158 20 August 2020
3.8 Markings on the Device
3.8.1 Identification Plate
The identification plates for identifying the device are located on the
right side of the casing, directly above the mains connection and on
the front of the door.
For information on the data provided on the identification plate see
chapter 1.3 "Device Identification (Standard Identification Plate)",
page 9.
3.8.2 Identification of the Throw
At the back wall inside the incubation chamber, there is a sticker that
identifies the throw of the device.