Multitron - Operating Manual
Options
Page 44 of 158 20 August 2020
4. Remove the level sensor:
a) Disconnect the mains cable of the level sensor.
b) Disconnect the connection cable on the solenoid valve.
c) Loosen the wing nut of the clamp.
d) Open and remove the clamp.
e) Remove the level sensor.
5. Remove the lid. To do so, loosen and unscrew the four cross-
head screws.
6. Carefully lift the lid upwards.
7. Clean the vessel and other components as required. For infor-
mation on correct cleaning, see the information below.
Detergents
For cleaning use a mild detergent, e.g. dishwashing liquid or neutral
cleaning agent.
To Next Page
Loading...
