Multitron - Operating Manual
Operation
Page 94 of 158 20 August 2020
INFORMATION
It takes a while for the parameters to reach the entered setpoint
value. The sign
High
or
Low
lights up, if the current value of a pa-
rameter is above respectively below its setpoint value.
Turning a parameter off
Turning off a parameter is carried out the same way as switching on
a parameter. The desired parameter can be selected by tapping the
Select key and afterwards switched off by tapping the ON/OFF key.
Is the parameter switched off, the message
OFF
appears on the al-
phanumeric display.
To Next Page
Loading...
