Ingenico iCT220 - How Do I

Introduction Terminal User Guide
4
How Do I …
To help you familiarise yourself with your terminal and to
understand the basics, below is a list of frequently asked
questions about the general operation of your terminal.
 … set up my terminal?
Follow the simple step-by-step installation checklist in the
next section.
 … turn my terminal on and off?
Your terminal is powered on automatically once the power
supply unit is plugged into the “Magic Cable” connector
unit. The terminal powers off when the power supply is
removed.
 … do a Sale or a Refund?
Step-by-step instructions for all types of sales and refunds
are given in the section entitled Transactions, these are
provided with screenshots of the terminal.
 … do my End of Day reports?
The section entitled Reports describes the End of Day
procedures. It is important to note that you should perform
your End of Day reports at the end of every trading day.
This will provide you with a full record of all your
transactions and ensure that your funds are processed in
the fastest possible time frame.
 … change my supervisor password?
Your terminal has a default Supervisor password of 01483,
you are required to change this password before you
process any transactions. Instructions on how to do so can
be found in the section entitled Supervisor Password.
 … change the paper roll?
Step-by-step instructions on how to load a new paper roll
into your terminal are provided in the section entitled
Paper Loading.