Ingenico iCT220 User Manual

Terminal User Guide Reports
67
Stored Report
A Stored Transaction report may be printed to show how many
transactions are stored in the terminal, awaiting transmission
to the host.
Up to five transactions may be stored in the terminal per
acquirer. A transaction may be stored after voice referral, or
by using the Forced Transaction or Hotel Mode Completion
functions.


Do not print this report unless instructed to do so by the
terminal Helpdesk.
To perform a Stored report for ALL acquirers press the menu
key twice, then choose REPORTS by pressing the F1 key. You
will be asked to type your supervisor password, then press
enter, press the menu key once more, choose STORED by
pressing the F1 key, followed by the F1 key to choose ALL.
 MENU, MENU, F1, [password], ENTER, MENU, F1, F1
To perform a Stored report for a SINGLE acquirer press the
menu key twice, then choose REPORTS by pressing the F1
key. You will be asked to type your supervisor password, then
press enter, press the menu key once more, choose STORED
by pressing the F1 key, followed by the F4 key to choose
SINGLE. Press F4 repeatedly for NEXT until the acquirer
required is displayed, select this by pressing enter.
 MENU, MENU, F1, [password], ENTER, MENU, F1, F4

Ingenico iCT220 Specifications

General

Weight	325 g
Display	128 x 64 pixels
Connectivity	Ethernet
Card Readers	Magnetic stripe
Security	PCI PTS 3.x certified
Processor	ARM9 32-bit RISC processor