Supervisor Functions Terminal User Guide
70
Supervisor Password Change (Initial Transaction)
If you have not changed the Supervisor password before you
process your first transaction the terminal will prompt you to
change the password from the default during the transaction.
A New Password
Must Be Selected
During the transaction, you will be
prompted that the password needs
to be changed, press any key to
continue.
Enter a new password and press the
enter key.
Re-enter the new password and
press the enter key.
A confirmation will be shown if the
two entries match and the password
has been changed.
The terminal will continue as normal, refer to the instructions
for transaction type that you chose to complete the
transaction.
Refund Password
Your terminal is configured to use the Supervisor password to
protect both the Refund and the Supervisor functions. If you
would like a separate password enabled in order to protect the
Refund function please contact the terminal Helpdesk.
This feature could be used to allow one member of staff the
added ability to perform a Refund; while allowing another
member(s) of staff the ability to perform the Supervisor
functions.
To Next Page
Loading...
