Ingenico iCT220 User Manual

Terminal User Guide Your Terminal
21
Swiping a Card
With the magnetic stripe facing down and towards the screen
as illustrated run the edge of the card along the bottom of the
card swipe slot on the right of your terminal. You should swipe
the card in one continuous movement and at an even speed.
If you see the prompt BAD SWIPE, check the orientation of the
card and try again. If the card cannot be read on the third
attempt, your terminal will prompt you for manual key entry of
the card number.
If a Chip Card is swiped, your terminal will request that you
insert the same card into the Chip card reader.
CHIP CARD
USE CHIP READER

Ingenico iCT220 Specifications

General

Weight	325 g
Display	128 x 64 pixels
Connectivity	Ethernet
Card Readers	Magnetic stripe
Security	PCI PTS 3.x certified
Processor	ARM9 32-bit RISC processor