Ingenico iCT220 User Manual

Terminal User Guide Supervisor Functions
71
Supervisor Menus
The Supervisor menus allow access to various management
functions in your terminal. To be able to access the Supervisor
menu, you must use the Supervisor password.
To access the Supervisor menus press the m enu key twice,
then choose SUPERVISOR by pressing the F3 key. You will be
asked to type your current supervisor password, and confirm
this by pressing the enter key.
 MENU, MENU, F3, [password], ENTER
Once you have access to the Supervisor menus, press the
menu key to cycle through the various menu screens.
Below is a summary of the Supervisor functions and how to
access them, and what they do.


Some Supervisor functions must only be used when
instructed to do so by the terminal Helpdesk.
First Supervisor Menu Screen
HANDSET ID
Allows the HANDSET ID value displayed on
the idle screen and printed on each ticket to
be set. The default value is 01.
PASSWORD
Allows the various passwords in the terminal
to be reset or changed. Enters the PASSWORD
menu - see next section.
CONFIG
Allows the access to various extended
configuration options. Enters the CONFIG
menu - see next section.
LOGON
Allows the terminal to make a test call to
some or all of the acquirers loaded on the
terminal. Do not use this feature unless
instructed to do so by the terminal Helpdesk.

Ingenico iCT220 Specifications

General

Weight	325 g
Display	128 x 64 pixels
Connectivity	Ethernet
Card Readers	Magnetic stripe
Security	PCI PTS 3.x certified
Processor	ARM9 32-bit RISC processor